Sensor, Crankshaft Position: Installation
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Install the Crankshaft Position Sensor (CKP) (1). Tighten the bolt (2) to the proper torque. Refer to TORQUE SPECIFICATIONS .
- Connect the CKP wire harness connector (3).
- Install the belly pan. Refer to BELLY PAN, INSTALLATION .
- Remove the support and lower the vehicle.
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.