Rail, Fuel: Installation: 2.4L
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Apply a light coating of clean engine oil to the O-ring on the nozzle end of each injector.
- If necessary, install the fuel injectors into the fuel rail using NEW
O-ring seals. Refer to INJECTOR(S), FUEL, INSTALLATION or INJECTOR(S), FUEL, INSTALLATION .
- Install the fuel rail (2). Tighten bolts (3) to the proper torque. Refer to TORQUE SPECIFICATIONS .
- Connect and lock the wire harness connectors (1).
- Connect the fuel line to fuel rail.
- Install the purge control valve. Refer to VALVE, PURGE CONTROL, INSTALLATION .
- Install the air cleaner resonator. Refer to RESONATOR, AIR CLEANER, INSTALLATION .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
- Use the Scan Tool Fuel System Test to pressurize the fuel system. Check for leaks.