Diagnostic Test

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

VERIFY THE DTC IS ACTIVE
1. Perform any Service Bulletins that may apply.
2. Turn the ignition on.
3. With the scan tool, record and erase the DTCs.
4. Cycle the ignition from off to on.
5. Press and hold the brake pedal.
6. Push the EPB Switch down to release the Electric Parking Brakes.
7. Pull the EPB Switch up to set the Electric Parking Brakes.
8. Push the EPB Switch down to release the Electric Parking Brakes.
9. Release the brake pedal.
10. Cycle the ignition from off to on.
11. With the scan tool, read EPB DTCs.
  Is the DTC active at this time?
  
  Yes
  - Replace the Electric Parking Brake (EPB) Module in accordance with Service Information. Refer to MODULE, ELECTRIC PARK BRAKE (EPBM), REMOVAL .
  - Perform the EPB VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Go To 2
CHECK THE WIRING AND CONNECTORS
1. The conditions necessary to set the DTC are not present at this time.
2. Using the schematics as a guide, inspect the wiring and connectors specific to this module. Wiggle the wiring and connectors while checking for shorted and open circuits.
3. Check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
4. Check Service Bulletins for any possible causes that may apply.
  Were there any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the EPB VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Test complete.