LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (2.4L Engine (Service Information)) >> Engine Mounting >> Insulator, Engine Mount, Right >> Removal

Insulator, Engine Mount, Right: Removal

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine cover.
  2. Remove the air cleaner assembly. Refer to REMOVAL  .
  3. Remove the coolant reservoir bolts. Set the reservoir aside.
  4. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  5. Remove the belly pan. Refer to BELLY PAN, REMOVAL .
  6. Support the powertrain with a suitable jack.
    GC0160072Courtesy of CHRYSLER GROUP, LLC
  7. Remove the three mount to timing cover bolts (1).
  8. Remove the two mount to frame bolts (2).
  9. Loosen, but do not remove the mount to strut tower bolt (4).
  10. Lift the mount off of the frame rail (5).
  11. Remove the engine mount (3).
scientia non olet · About LEMON Manuals