Pipe, Exhaust CROSSUNDER: Installation: 3.2L
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Loosely install cross-under pipe (4) to the front catalytic converter.
- Connect the resonator pipe to the cross-under pipe (1) and tighten the nuts (3) to 26 N.m (19 ft. lbs.).
- Install the center support bolt (5) and tighten the bolt to 25 N.m (18 ft. lbs.).
- Tighten the cross-under pipe to catalytic convertor flange nuts (6) to 26 N.m (19 ft. lbs.).
- Install the belly pan. Refer to BELLY PAN, INSTALLATION .
- Remove the support and lower the vehicle.
- Start the engine and inspect for exhaust leaks. Repair exhaust leaks as necessary.
- Check the exhaust system for contact with the body panels. Make the necessary adjustments, if needed.