Antenna, Remote Start: Removal
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Lower the rear of the headliner. Refer to HEADLINER, REMOVAL
.
- Disconnect the Remote Start Antenna (RSA) connector (3) from the Radio Frequency Hub (RF-Hub) (4).
- Remove the two fasteners (1) securing the RSA (2) to the roof.