LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Power Locks (Service Information)) >> Antenna, Passive Entry >> Removal >> Rear Door

Rear Door

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
GC0159405Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the trim panel from the inside of the rear door. Refer to PANEL, REAR DOOR TRIM, REMOVAL .
  3. Disconnect the door wire harness connector (3) from the Low Frequency (LF) antenna connector receptacle.
  4. Remove the two screws that secure the antenna (2) to the inside of the rear door hardware module carrier.
  5. Remove the antenna (1) from the carrier.
scientia non olet · About LEMON Manuals