LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Power Locks (Service Information)) >> Antenna, Passive Entry >> Installation >> Rear Fascia Bracket

Rear Fascia Bracket

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
GC0159637Courtesy of CHRYSLER GROUP, LLC
  1. Position the Low Frequency (LF) antenna (2) in the pocket near the center of the rear fascia bracket.
  2. Reconnect the wire harness connector (1) to the connector receptacle for the antenna.
  3. Align the antenna with the retainers integral to the rear fascia bracket, then slide it downward until it snaps into place.
  4. Reinstall the rear fascia onto the vehicle. Refer to FASCIA, REAR, INSTALLATION .
  5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
scientia non olet · About LEMON Manuals