Fascia, Rear: Installation
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- With the help of an assistant, position the fascia (4) to the vehicle.
- Connect the vehicle wiring harness.
- With the help of an assistant and using firm pressure, align and push forward to engage the fascia to the rear retaining bracket.
- Align the fascia (4) with the retaining brackets at the tail lamp (1) and wheelhouse openings (2). Using firm pressure push in to engage. Repeat on the opposite side.
- Accessing from the wheelhouse, install the fastener (1) that secures the rear fascia assembly to the rear quarter. Tighten the fastener securely. Repeat for opposite side.
- Install the fasteners (3) that secures the rear fascia assembly to the underbody.
- Install the wheelhouse splash shields. Refer to SHIELD, SPLASH, REAR WHEELHOUSE, INSTALLATION .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.