Cover, Rear Seat Cushion, 60%: Installation
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Position the seat cushion cover onto the seat cushion foam and install NEW hog rings.
- Pull the seat cover tight and engage the velcro fasteners.
- Position the seat cushion assembly onto the seat frame.
- If equipped with heated seat, route the wire harness and connect the wire harness connector.
- Install the screw (1) connecting the air bag tether to the seat frame.
- Connect the electrical connectors.
- Secure the seat cushion fastener strips to the seat frame.
- Secure the cross straps (1).
- Secure the J-clips straps (1) to the cushion supports.
- Install the seat assembly. Refer to SEAT, REAR, INSTALLATION .