Seat, Rear: Installation
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- If necessary, install the 60% seat into the vehicle.NOTE:
The 60% seat must be installed into the vehicle before the 40% seat. The brackets (1 and 3) overlap.
- Install the 40% seat into the vehicle.
- Install a NEW
rivet (2) into the front seat brackets.
- Install the bolt (4) that fastens the rear seat brackets, and tighten securely
- Install all the rear seat nuts and bolts loosely, then tighten the rear seat bolts to the proper. Refer to TECHNICAL SPECIFICATIONS .
- Tighten the rear seat nuts (1) to the proper. Refer to TECHNICAL SPECIFICATIONS .
- If equipped, connect the wire harness connectors (2).
- Install the front bolt trim covers.
- Connect the negative battery cable(s). Refer to STANDARD PROCEDURE .