LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Body - Interior & Exterior) >> Seats, Rear >> Cover, Rear Seat Cushion, 40% >> Installation

Cover, Rear Seat Cushion, 40%: Installation

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the seat cushion cover onto the seat cushion foam and install NEW  hog rings.
  2. Pull the seat cover tight and engage the velcro fasteners.
  3. Position the seat cushion assembly onto the seat frame.
  4. If equipped with heated seat, route the wire harness and connect the wire harness connector.
    GC0162250Courtesy of CHRYSLER GROUP, LLC
  5. Install the screw (1) connecting the air bag tether to the seat frame.
  6. Connect the electrical connector.
  7. Secure the seat cushion fastener strips to the seat frame.
    GC0176937Courtesy of CHRYSLER GROUP, LLC
  8. Secure the J-clips straps (1) to the cushion supports.
  9. Install the seat assembly. Refer to SEAT, REAR, INSTALLATION .
scientia non olet · About LEMON Manuals