Diagnostic Test

WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.

SRI MILEAGE NOT PROGRAMMED INTO THE PCM

Ignition on, engine not running.
With the scan tool, attempt to program the SRI mileage into the PCM.
With the scan tool, clear DTCs in the PCM.
Start the engine.
Allow the engine to reach normal operating temperature.
With a scan tool, select View DTCs.
Is the status Active for this DTC?

Yes
- Replace and program the Powertrain Control Module in accordance with the Service Information. Refer to MODULE, POWERTRAIN CONTROL, REMOVAL .
- Perform the PCM VERIFICATION Test. Refer to PCM VERIFICATION TEST .
No
- The SRI mileage has been successfully programmed into the PCM. Test is complete.
- Perform the PCM VERIFICATION Test. Refer to PCM VERIFICATION TEST .