Injector(S), Fuel: Removal: 2.4L

WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Fuel Injector Electrical Connectors

Courtesy of CHRYSLER GROUP, LLC

WARNING:

Risk of injury to eyes and skin from contact with fuel. Wear protective clothing and eye protection. Risk of poisoning from inhaling and swallowing fuel. Pour fuel only into appropriately marked and approved containers. Failure to follow these instructions may result in possible serious or fatal injury.

Release the fuel pressure. Refer to FUEL SYSTEM PRESSURE RELEASE PROCEDURE .
Disconnect and isolate negative battery cable.
Remove engine cover.
Unlock and disconnect the electrical connectors from the fuel injectors.

Fig 2: Fuel Line At Rail
Courtesy of CHRYSLER GROUP, LLC
Disconnect the fuel line from the fuel rail. Refer to FITTING, QUICK CONNECT .

Fig 3: Harness Clips
Courtesy of CHRYSLER GROUP, LLC
Remove wire harness from fuel rail mounting studs.

Fig 4: Electrical Harness Removed
Courtesy of CHRYSLER GROUP, LLC
Remove the 2 bolts from the fuel rail at the lower manifold.

Fig 5: Rail Removal/Install
Courtesy of CHRYSLER GROUP, LLC
Remove the fuel rail and injectors from the intake manifold.

Fig 6: Fuel Injector On Rail
Courtesy of CHRYSLER GROUP, LLC
Remove fuel injector clip holding fuel injector to fuel rail.

Fig 7: Fuel Injector And Rail
Courtesy of CHRYSLER GROUP, LLC
Remove fuel injector from fuel rail.