LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Fuel System) >> Fuel Delivery, Gas >> Standard Procedure >> Fuel System Pressure Release Procedure

Fuel System Pressure Release Procedure

WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove fuel fill cap.
  2. Remove fuel pump fuse from Totally Integrated Power Module (TIPM). For location of fuse, refer to label on underside of TIPM cover.
  3. Start and run engine until it stalls.
  4. Attempt restarting engine until it will no longer run.
  5. Turn ignition key to OFF position.
  6. Place a rag or towel below fuel line quick-connect fitting at fuel rail.
  7. Disconnect quick-connect fitting at fuel rail. Refer to FITTING, QUICK CONNECT  .
  8. When the repair is complete, reconnect fuel fittings and return fuel pump fuse to TIPM.
  9. One or more Diagnostic Trouble Codes (DTC's) may have been stored in PCM memory due to fuel pump fuse removal. A diagnostic scan tool must be used to erase a DTC.
scientia non olet · About LEMON Manuals