Front Curb Height

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The suspension is non-adjustable.

The vehicle suspension height should be measured before performing wheel alignment procedure. Also when front suspension components have been replaced. This measure must be performed with the vehicle supporting it's own weight and taken on both sides of the vehicle.

Front and rear curb heights are not adjustable. The spring selections at assembly determine curb height for acceptable appearance of the vehicle. Curb height dimensions assume full fluids (including fuel) and zero passengers. Refer to the CURB HEIGHT SPECIFICATIONS table below for front curb height dimensions.

Vehicle curb height audits should be performed utilizing the following procedure:

NOTE:

Make sure the vehicle is in 2WD when checking curb height.

Front - On each side of the vehicle, measure the distance from the bottom of the frame rail to the top of the axle tube.

Fig 1: Measuring Front Curb Height

Courtesy of CHRYSLER GROUP, LLC

Bounce the front of the vehicle five times.
Measure and record the dimensions