Park Assist Sensor: Installation

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Park Assist Sensor Bracket/Bezel Removal/Installation

Courtesy of DAIMLERCHRYSLER CORP.

If replacing the sensor retaining bracket (1), snap the sensor (2) into the bracket until it seats fully.

Fig 2: Park Assist Sensor From Fascia Removal/Installation
Courtesy of DAIMLERCHRYSLER CORP.
Position the Park Assist Sensor (1) over the retaining bracket (2) and firmly snap into housing in rear fascia.

Fig 3: Fascia
Courtesy of DAIMLERCHRYSLER CORP.
Install the rear fascia (Refer to FRAME & BUMPERS/BUMPERS/REAR FASCIA - INSTALLATION) .
Connect the battery negative cable.