LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 593 (Wiper System & Washer System (Service Information)) >> Front Wiper Module >> Removal

Front Wiper Module: Removal

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Front Wiper Module R/I
GC0029500Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect and isolate the negative battery cable.
  2. Remove both front wiper arms (Refer to ELECTRICAL/FRONT WIPERS/WASHERS/FRONT WIPER ARMS - REMOVAL) .
  3. Remove the cowl plenum cover/grille panel (Refer to BODY/EXTERIOR/COWL GRILLE - REMOVAL) .
  4. Remove the nut (1) and the two bolts (2) that secure the front wiper module to the cowl plenum panel.
  5. Disconnect the wire harness connector (4) from the front wiper motor (3).
  6. Remove the front wiper module from the cowl plenum.