Section 590 (Frame & Bumpers): Fascia-Front: Removal

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Fascia

Courtesy of DAIMLERCHRYSLER CORP.

Remove the grille. (Refer to BODY/EXTERIOR/GRILLE - REMOVAL)
Remove the push pin fasteners (4) along the top of the fascia (1).

Fig 2: Fascia To Wheel Liner
Courtesy of DAIMLERCHRYSLER CORP.
Remove the plastic rivets (3) at each wheelhouse splash shield (1).

Fig 3: Fascia To Fender
Courtesy of DAIMLERCHRYSLER CORP.
Remove the screws (3) from inside the fascia (2).

Fig 4: Lower Fascia
Courtesy of DAIMLERCHRYSLER CORP.
Remove the three lower screws (2).
Disconnect the fog lamp electrical connectors (1), if equipped.