LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 573 (NV245 Transfer Case (Service Information)) >> NV245 - Service Information >> Seal-Rear Output Shaft >> Installation

Seal-Rear Output Shaft: Installation

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Remove/Install Rear Output Shaft Flange
GC0027441Courtesy of DAIMLERCHRYSLER CORP.
1 - REAR COMPANION FLANGE
2 - OUTPUT SHAFT
  1. Install a new rear output shaft seal into the rear cover with Installer C-3972A.
  2. Install the rear output shaft flange (1) onto the output shaft (2). See Fig 1.
    Fig 2: Remove/Install Rear Output Shaft Nut
    GC0027440Courtesy of DAIMLERCHRYSLER CORP.
    1 - HOLDER C-3281
    2 - REAR COMPANION FLANGE
  3. Using Holder C-3281 (1), install the rear companion flange (2) nut. Tighten the bolts to 122-176 N.m (90-130 ft. lbs.). See Fig 2.
  4. Install the rear propeller shaft. Refer to INSTALLATION .
  5. Check the transfer case fluid level. (Refer to TRANSMISSION/TRANSFER CASE/FLUID - STANDARD PROCEDURE) . Correct as necessary.
scientia non olet · About LEMON Manuals