Rear Center
WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
During and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or inoperative buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or faulty seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler Mopar Parts Catalog.
- Remove the left rear seat back panel (4) from the vehicle. (Refer to REMOVAL ).
- Remove the trim from the left rear seat back. (Refer to REMOVAL ).
- Disengage the seat belt lower anchor through the web guide loop integral to the top of the seat back panel.
- Disengage the retractor lock cable (2) end fitting from the seat back latch mechanism (3) on the upper outboard corner of the seat back panel.
- Disengage the lock cable from the back panel between the latch and the retractor (1).
- Remove the screw (2) from the back of the seat back panel (1) that secures the retractor.
- Remove the rear center seat belt and retractor unit from the front of the left seat back panel.