Seal-Output Shaft: Removal

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

For 2WD transmissions;
- Remove the propeller shaft (Refer to DIFFERENTIAL & DRIVELINE/PROPELLER SHAFT/PROPELLER SHAFT - REMOVAL) . Move propeller shaft to the right and tie up.
- Remove the nut holding the propeller shaft flange to the output shaft and remove the flange.
For 4WD transmissions:
- Remove the transfer case (Refer to TRANSMISSION/TRANSFER CASE - REMOVAL) or (Refer to TRANSMISSION/TRANSFER CASE - REMOVAL) .
- Remove the bolts holding the transfer case adapter housing onto the transmission case.
- Remove the transfer case adapter housing from the transmission case.
- Remove the bolt holding the output shaft extension to the output shaft.
- Remove the output shaft extension from the output shaft.
Remove the output shaft seal with suitable screw and slide hammer.