LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 562 (HVAC Systems (Service Information)) >> Controls >> Sensor-Ambient Air Temperature >> Removal

Sensor-Ambient Air Temperature: Removal

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Sensor-Ambient Temperature R and I
GC0028316Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect and isolate the negative battery cable.
  2. Remove the grille (Refer to BODY/EXTERIOR/GRILLE - REMOVAL) .
  3. Disconnect the wire harness connector (1) from the ambient air temperature sensor (2) located at the top of the front bumper beam (3).
  4. Disengage the ambient air temperature sensor from the retaining tabs (4) and remove the sensor.
scientia non olet · About LEMON Manuals