LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 546 (5.7L Engine (Service Information)) >> Retainer-Crank Rear Oil - Seal >> Installation

Retainer-Crank Rear Oil - Seal: Installation

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Seal Retainer Torque Sequence
GC0003976Courtesy of DAIMLERCHRYSLER CORP.
  1. Thoroughly clean all gasket residue from the engine block.
  2. Use extreme care and clean all gasket residue from the retainer.
  3. Position the gasket onto the retainer.
  4. Position the retainer onto the engine block.
  5. Install the retainer mounting bolts. Tighten the bolts to 15 N.m (132 in. lbs.) using the procedure shown.
  6. Install the oil pan. (Refer to ENGINE/LUBRICATION/OIL PAN - INSTALLATION) .
  7. Install the flexplate. (Refer to ENGINE/ENGINE BLOCK/FLEX PLATE - INSTALLATION) .
  8. Install the transmission (Refer to TRANSMISSION/TRANSAXLE/AUTOMATIC - NAG1 - INSTALLATION) .
  9. Check and verify engine oil level.
  10. Start engine and check for leaks.
scientia non olet · About LEMON Manuals