LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 545 (4.7L Engine (Service Information)) >> Pump - Engine Oil >> Installation

Pump - Engine Oil: Installation

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Oil Pump and Primary Timing Chain Tensioner Tightening Sequence
GC0003857Courtesy of DAIMLERCHRYSLER CORP.
  1. Position the oil pump onto the crankshaft and install one oil pump retaining bolts.
  2. Position the primary timing chain tensioner and install three retaining bolts.
  3. Tighten the oil pump and primary timing chain tensioner retaining bolts to 28 N.m (250 in. lbs.) in the sequence shown.
  4. Install the secondary timing chain tensioners and timing chains (Refer to ENGINE/VALVE TIMING/TIMING BELT/CHAIN AND SPROCKETS - INSTALLATION) .
  5. Install the timing chain cover (Refer to ENGINE/VALVE TIMING/TIMING BELT / CHAIN COVER(S) - INSTALLATION) .
  6. Install the pick-up tube and oil pan (Refer to ENGINE/LUBRICATION/OIL PAN - INSTALLATION) .
scientia non olet · About LEMON Manuals