LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 545 (4.7L Engine (Service Information)) >> Pan - Engine Oil >> Installation

Pan - Engine Oil: Installation

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Oil Pan Mounting Bolts and Oil Pan
GC0003929Courtesy of DAIMLERCHRYSLER CORP.
  1. Clean the oil pan gasket mating surface of the bedplate and oil pan.
  2. Position the oil pan gasket and pickup tube with new o-ring. Install the mounting bolt and nuts. Tighten bolt and nuts to 28 N.m (20 ft. lbs.).
  3. Position the oil pan and install the mounting bolts. Tighten the mounting bolts to 15 N.m (11 ft. lbs.) in the sequence shown.
    Fig 2: ENGINE SUPPORT TOOL
    GC0027248Courtesy of DAIMLERCHRYSLER CORP.
  4. Lower the engine into mounts using special tool (1) # 8534.
    Fig 3: ENGINE MOUNT BOLT
    GC0027247Courtesy of DAIMLERCHRYSLER CORP.
  5. Install both the left and right side engine mount through bolts (3). Tighten the nuts to 68 N.m (50 ft. lbs.).
  6. Remove special tool # 8534.
    Fig 4: Structural Cover
    GC0027249Courtesy of DAIMLERCHRYSLER CORP.
  7. Install structural dust cover.
  8. Fill engine oil.
  9. Reconnect the negative battery cable.
  10. Start engine and check for leaks.
scientia non olet · About LEMON Manuals