LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 544 (3.7L Engine (Service Information)) >> Crankshaft Oil Seal - Rear >> Installation

Crankshaft Oil Seal - Rear: Installation

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Crankshaft Rear Oil Seal Guide Special Tool 8349-2 and Oil
GC0011784Courtesy of DAIMLERCHRYSLER CORP.
  1. Lubricate the crankshaft flange with engine oil.
  2. Position the magnetic seal guide Special Tool 8349-2 (2) onto the crankshaft rear face. Then position the crankshaft rear oil seal (1) onto the guide.
    Fig 2: Crankshaft Rear Oil Seal Installation
    GC0011785Courtesy of DAIMLERCHRYSLER CORP.
  3. Using Special Tools 8349 Crankshaft Rear Oil Seal Installer (2) and C-4171 Driver Handle (3), with a hammer, tap the seal (1) into place. Continue to tap on the driver handle until the seal installer seats against the cylinder block crankshaft bore.
  4. Install the flexplate (Refer to ENGINE/ENGINE BLOCK/FLEX PLATE - INSTALLATION) .
  5. Install the transmission.
scientia non olet · About LEMON Manuals