LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 540 (Body - Interior & Exterior) >> Liftgate >> Latch >> Installation

Section 540 (Body - Interior & Exterior): Liftgate: Latch: Installation

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: LATCH
GC0027947Courtesy of DAIMLERCHRYSLER CORP.
  1. Position the latch (1) onto the inside of the liftgate.
  2. Install and tighten the three bolts (2) that secure the latch (1)to the studs on the inside of the liftgate. Tighten the nuts to 12 N.m (9 ft. lbs.).
    Fig 2: ELECTRICAL CONNECTORS
    GC0027946Courtesy of DAIMLERCHRYSLER CORP.
  3. Connect electrical connectors (2) to the latch (1).
  4. Reinstall the lower trim panel onto the inside of the liftgate. (Refer to BODY/DECKLID/HATCH/LIFTGATE/TAILGATE/TRIM PANEL - INSTALLATION) .
  5. Reconnect the battery negative cable.
  6. Close the liftgate.
scientia non olet · About LEMON Manuals