Module-Steering Control: Disassembly
WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- With the SCM (4) removed (Refer to STEERING/COLUMN/STEERING COLUMN CONTROL MODULE - REMOVAL) , remove the hazard switch by releasing the tangs (2) and sliding the switch (1) out of position.
- Remove the two screws (1) for the right multi-function (wiper/washer) switch (2). The left multi-function (lighting control) switch will be mounted on the left side of the SCM the exact same way. The connectors are integral to the SCM and are self docking.
- Using a trim stick (special tool #C-4755) or equivalent, gently pry in on the three tabs holding the turn signal cancel cam to the SCM. You must go in through the front of the SCM to release the tabs. Be careful not to break tabs if reusing the cancel cam for they are brittle.