Front Parking Brake Cable
WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery cable.
1 - SEAT BOLT 2 - BRACKET - Remove the drivers seat (Refer to BODY/SEATS/SEAT - REMOVAL) .
- Remove the left sill plate.
- Remove the left B-pillar trim panel (Refer to BODY/INTERIOR/B-PILLAR UPPER TRIM - REMOVAL) .
- Remove the console rear cover (2) or the DVD player (if equipped).
- Remove center console (1), (Refer to BODY/INTERIOR/FLOOR CONSOLE - REMOVAL)
.
1 - SEAT BOLT 2 - BRACKET - Remove the rear seat bottom (Refer to BODY/SEATS/SEAT CUSHION - REMOVAL)
.
1 - ELECTRICAL CONNECTORS 2 - BRACKET - Disconnect the modules electrical connectors (1).
- Remove the module mounting nuts from the bracket (2).
- Remove the rear sill plates.
- Pull and roll the rear carpet upwards to gain access to the front park brake cable.
1 - FRONT CABLE 2 - LOCK OUT PLIERS 3 - REAR CABLES - Lock out the front park brake cable.
1 - EQUALIZER 2 - CABLE - Remove the front cable (2) at the equalizer (1).
1 - PARK BRAKE LEVER 2 - NUT 3 - CABLE 4 - NUT - Remove the 2 front cable routing clamps and the 3 nuts (2&4).
- Remove the front cable at the rear floor bracket.
- Remove the front cable (3) at the hand lever (1).
- Remove the front cable at the hand lever mounting bracket.