B-Pillar Upper Trim: Removal
WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Firmly grasp the lower end of the turning loop trim cover on the upper B-pillar and pull it straight out to unsnap it from the height adjuster, then lift the bottom of the cover upward and pull outward to disengage the upper tabs from the adjuster.
- Remove the screw that secures the seat belt turning loop to the height adjuster.
- Remove the seat belt turning loop from the height adjuster and position the seat belt out of the way.
- Using a trim stick C-4755 or equivalent, disengage the retaining tabs that secure the upper B-pillar trim panel to the B-pillar and remove the trim panel.