Left Side

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: All torques should be done with vehicle on the ground with full vehicle weight.

Fig 1: Suspension Arms

Courtesy of DAIMLERCHRYSLER CORP.

1 - NUT

2 - UPPER SUSPENSION ARM

3 - UPPER SPRING ISOLATOR

4 - JOUNCE BUMPER RETAINER

5 - BOLT

6 - JOUNCE BUMPER

7 - UPPER FLAG BOLT

8 - LOWER FLAG BOLT

9 - LOWER SUSPENSION ARM

Position the upper suspension arm (2) in the frame rail bracket.

Install the mounting bolt (5) and nut (1) tighten to 129 N.m (95 ft. lbs.).

Fig 2: Upper Suspension Arm

Courtesy of DAIMLERCHRYSLER CORP.

1 - ISOLATOR

2 - NUT

3 - BOLT

4 - UPPER SUSPENSION ARM

Position the upper suspension arm (4) in the axle bracket.
Install the mounting bolt (3) and nut (2) tighten to 136 N.m (100 ft. lbs.).
Raise the fuel tank back into place and secure (Refer to FUEL SYSTEM/FUEL DELIVERY/FUEL TANK - INSTALLATION) .
Remove the supports and lower the vehicle.