Fuel Delivery: Tank-Fuel: Installation

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removal And Installation Fuel / EVAP Lines-Fuel Tank

Courtesy of DAIMLERCHRYSLER CORP.

If fuel tank is to be replaced, install fuel pump module into tank. Refer to MODULE-FUEL PUMP procedures.
Position fuel tank to hydraulic jack.
Raise tank until positioned to body.
Install and tighten bolts (1) (2) and (3). Refer to SPECIFICATIONS .
Remove hydraulic jack.

Fig 2: Identifying Fuel Filler Tubes
Courtesy of DAIMLERCHRYSLER CORP.
Connect EVAP, ORVR, fuel and NVLD lines at front and rear of tank.
Connect fuel pump module electrical jumper connector (5) to body connector (6).

Fig 3: Identifying Fuel Filler Tubes
Courtesy of DAIMLERCHRYSLER CORP.
Connect rubber fill hose (3) to tank fitting (7) and tighten clamp (9).
Lower vehicle.
Fill fuel tank with fuel.
Start engine and check for fuel leaks near top of module.