Section 534 (Suspension System (Service Information)): Front: Hub/Bearing: Installation

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Wheel Speed Sensor

Courtesy of DAIMLERCHRYSLER CORP.

1 - WHEEL SPEED SENSOR WIRE

2 - NUT

3 - HUB/BEARING

Install the hub bearing (3) to the knuckle.
Install the hub bearing to knuckle and the 3 bolts then tighten to 136 N.m (100 ft. lbs.).
Install the wheel speed sensor (Refer to BRAKES/ELECTRICAL/FRONT WHEEL SPEED SENSOR - INSTALLATION) .
Install the wheel speed sensor nut (2).

Fig 2: O-Ring
Courtesy of DAIMLERCHRYSLER CORP.

1 - ROTOR

2 - O-RING

Install the brake rotor (1) (Refer to BRAKES/HYDRAULIC/MECHANICAL/ROTORS - INSTALLATION) .

Fig 3: Caliper Adapter

Courtesy of DAIMLERCHRYSLER CORP.

1 - CALIPER ADAPTER

2 - KNUCKLE

3 - CALIPER ADAPTER BOLTS

4 - ROTOR

Install the brake caliper adaptor (1) (Refer to BRAKES/HYDRAULIC/MECHANICAL/DISC BRAKE CALIPER ADAPTER - INSTALLATION) .

Fig 4: Caliper

Courtesy of DAIMLERCHRYSLER CORP.

1 - CALIPER

2 - CALIPER BOLTS

3 - CALIPER ADAPTER BOLTS

4 - ADAPTER

5 - BRAKE HOSE

6 - BANJO BOLT WITH COPPER WASHERS

Install the caliper (1) (Refer to BRAKES/HYDRAULIC/MECHANICAL/DISC BRAKE CALIPERS - INSTALLATION) .
Install the wheel and tire assembly (Refer to TIRES/WHEELS - STANDARD PROCEDURE) .
Remove the support and lower the vehicle.