Park/Turn Signal Lamp: Removal: Bulb
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - LAMP |
| 2 - SOCKET |
| 3 - BULB |
- Disconnect and isolate the battery negative cable.
- Remove the front park/turn signal lamp unit from the front fascia. LAMP .
- Firmly grasp the park/turn signal bulb socket on the back of the front lamp unit housing and rotate it counterclockwise about 30 degrees to unlock it. See Fig 1.
- Pull the socket and bulb straight out from the keyed opening in the housing.
- Pull the base of the bulb straight out of the socket.