Park/Turn Signal Lamp: Removal: Lamp

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Park/Turn Signal Lamp Unit Remove/Install

Courtesy of DAIMLERCHRYSLER CORP.

1 - LAMP

2 - FENDER FLARE

3 - SCREW

4 - FASCIA

Disconnect and isolate the battery negative cable.

Remove the screw that secures the inboard side of the front park/turn signal lamp unit to the front bumper fascia. See Fig 1.

Fig 2: Front Park/Turn Signal Lamp Connection

Courtesy of DAIMLERCHRYSLER CORP.

1 - SLOT

2 - CONNECTOR

3 - PLASTIC NUT

4 - LAMP

Pull the inboard side of the lamp away from the fascia far enough to disengage the tab that secures the outboard side of the lamp from the slot in the front bumper fascia. See Fig 2.
Disengage the lock feature and disconnect the wire harness connector from the lamp socket.
Remove the front park/turn signal lamp unit from the vehicle.