Park/Turn Signal Lamp: Installation: Bulb
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket and/or the lamp wiring.
- Align the base of the bulb with the park/turn signal bulb socket. See Figure.
- Push the bulb straight into the socket until the base is firmly seated.
- Align the socket and bulb with the keyed opening on the back of the front park/turn signal lamp unit housing.
- Insert the socket and bulb into the housing until the socket is firmly seated.
- Rotate the socket clockwise about 30 degrees to lock it into place.
- Reinstall the front park/turn signal lamp unit onto the front fascia. (Refer to LAMP ).
- Reconnect the battery negative cable.