LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 516 (Lighting Systems - Exterior) >> Park/Turn Signal Lamp >> Installation >> Lamp

Park/Turn Signal Lamp: Installation: Lamp

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check to be certain that the plastic nut is in good condition and properly installed in the inboard side of the front park/turn signal lamp mounting hole in the front bumper fascia. See Figure.
  2. Position the lamp unit near the mounting hole in the fascia.
  3. Reconnect the wire harness connector to the lamp socket and engage the lock feature.
  4. Align and engage the tab on the outboard side of the lamp housing with the slot in the fascia mounting hole.
  5. Position the inboard side of the lamp into the fascia mounting hole. See Figure.
  6. Install and tighten the screw that secures the inboard side of the lamp to the fascia. Tighten the screw to 2 N.m (20 in. lbs.).
  7. Reconnect the battery negative cable.
scientia non olet · About LEMON Manuals