Gearshift Adjustment Procedure

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

Shift transmission into PARK.
Remove floor console as necessary for access to the shift cable adjustment. (Refer to BODY/INTERIOR/FLOOR CONSOLE - REMOVAL)

Loosen the shift cable adjustment screw. See Fig 1.

Fig 1: Transmission Shift Cable At Shifter

Courtesy of DAIMLERCHRYSLER CORP.

1 - SHIFTER ASSEMBLY

2 - GEARSHIFT CABLE

3 - BTSI CABLE

Raise vehicle.
Unsnap cable eyelet from transmission shift lever.
Verify transmission shift lever is in PARK detent by moving lever fully rearward. Last rearward detent is PARK position.
Verify positive engagement of transmission park lock by attempting to rotate propeller shaft. Shaft will not rotate when park lock is engaged.
Snap cable eyelet onto transmission shift lever.
Lower vehicle
Tighten the shift cable adjustment screw to 7 N.m (65 in.lbs.).
Verify correct operation.
Install any floor console components removed for access. (Refer to BODY/INTERIOR/FLOOR CONSOLE - INSTALLATION)