Floor Console: Removal

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

Remove the shift bezel, if equipped. (Refer to BODY/INTERIOR/SHIFT BEZEL - REMOVAL) .
Set park brake lever in the up position.
Using a trim stick C-4755 or equivalent, disconnect the manual trans shifter boot, if equipped.
Using a trim stick C-4755 or equivalent, disconnect the transfer case shifter boot, if equipped.
Remove the four bolts. See Fig 1.
Lift the console at the back and remove.

Fig 1: Floor Console

Courtesy of DAIMLERCHRYSLER CORP.

1 - SHIFT BEZEL

2 - ACCESSORY CUP

3 - BOLTS (4)

4 - FLOOR CONSOLE