Flip-Up Glass: Removal

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

Open the flip-up glass and disconnect the electrical connectors.
Remove the support cylinders. (Refer to BODY/SWING GATE/FLIP-UP GLASS SUPPORT CYLINDER - REMOVAL) .
Open the glass to the full travel with the support cylinders off.
Remove the bolts and remove the glass. See Fig 1.

Fig 1: Flip-Up Glass

Courtesy of DAIMLERCHRYSLER CORP.

1 - BOLTS (4)

2 - HINGE MOUNTING HOLES

3 - DEFROSTER WIRE HARNESS

4 - DEFROSTER ELECTRICAL CONNECTOR

5 - FLIPPER GLASS