Flip-Up Glass Latch: Removal

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

Remove the trim panel. (Refer to BODY/SWING GATE/TRIM PANEL - REMOVAL) .
Disconnect the electrical connectors. See Fig 1.
Using a grease pencil or equivalent, mark the location of the latch assembly for installation.
Remove the nuts and remove the latch assembly.

Fig 1: Flip-Up Glass Latch

Courtesy of DAIMLERCHRYSLER CORP.

1 - NUTS (2)

2 - ELECTRICAL CONNECTOR

3 - SWING GATE

4 - ELECTRICAL CONNECTOR

5 - FLIP-UP GLASS LATCH