Timing Belt/Chain TENSIONER & Pulley: Removal

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: TIMING BELT AND SPROCKETS

Courtesy of DAIMLERCHRYSLER CORP.

1 - CAMSHAFT SPROCKETS

2 - INJECTION PUMP SPROCKET

3 - INJECTION PUMP SPROCKET RETAINING NUT

4 - TIMING BELT TENSIONER

5 - TIMING BELT

6 - IDLER PULLEY

NOTE: Before servicing the timing belt, the engine must be rotate to 90 degrees ATDC (Refer to ENGINE/VALVE TIMING - STANDARD PROCEDURE) .

Disconnect negative battery cable.
Remove engine cover. Refer to ENGINE COVER .
Remove cooling fan and fan drive viscous clutch assembly. Refer to RADIATOR - FAN - VISCOUS .
Remove accessory drive belt (Refer to COOLING/ACCESSORY DRIVE/DRIVE BELTS - REMOVAL) .
Remove cooling fan support (Refer to COOLING/ENGINE/RADIATOR FAN - REMOVAL) .
Remove vibration damper (Refer to ENGINE/ENGINE BLOCK/VIBRATION DAMPER - REMOVAL) .
Remove the power steering pump pulley.
Remove timing belt outer cover (Refer to ENGINE/VALVE TIMING/TIMING BELT/CHAIN COVER(S) - REMOVAL) .
Loosen and remove timing belt tensioner. See Fig 1.