LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 502 (2.8L Diesel Engine (Service Information)) >> Timing Belt/Chain Cover(S) >> Removal >> Removal - Timing Belt Outer Cover

Removal - Timing Belt Outer Cover

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable.
  2. Remove engine cover. Refer to ENGINE COVER .
  3. Remove cooling fan and fan drive viscous clutch assembly. Refer to RADIATOR - FAN - VISCOUS .
  4. Remove accessory drive belt (Refer to COOLING/ACCESSORY DRIVE/DRIVE BELTS - REMOVAL) .
  5. Remove cooling fan support (Refer to COOLING/ENGINE/RADIATOR FAN - REMOVAL) .
  6. Remove the power steering pump pulley.
  7. Remove vibration damper (Refer to ENGINE/ENGINE BLOCK/VIBRATION DAMPER - REMOVAL) .
  8. Remove timing belt outer cover retaining bolts and remove cover. See Fig 1.
    Fig 1: TIMING BELT OUTER COVER
    GC0026252Courtesy of DAIMLERCHRYSLER CORP.
    1 - TIMING BELT
    2 - TIMING BELT OUTER COVER
    3 - TIMING BELT OUTER COVER RETAINING BOLTS
scientia non olet · About LEMON Manuals