LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 500 (2.4L Engine (Service Information)) >> Hydraulic Lifters >> Removal

Hydraulic Lifters: Removal

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: This procedure is for in-vehicle service with camshafts installed.
  1. Remove cylinder head cover. (Refer to ENGINE/CYLINDER HEAD/CYLINDER HEAD COVER(S) - REMOVAL) 
  2. Remove the camshafts (Refer to ENGINE/CYLINDER HEAD/CAMSHAFT(S) - REMOVAL) .
  3. Remove rocker arm. (Refer to ENGINE/CYLINDER HEAD/ROCKER ARMS - REMOVAL) 
  4. Remove hydraulic lifter. See Fig 1.
  5. Repeat removal procedure for each hydraulic lifter.
  6. If reusing, mark each hydraulic lifter for reassembly in original position. Lifters are serviced as an assembly.
Fig 1: Hydraulic Lash Adjuster
GC0021202Courtesy of DAIMLERCHRYSLER CORP.
scientia non olet · About LEMON Manuals