LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 497 (HVAC Systems) >> Plumbing >> A/C Evaporator >> Installation

A/C Evaporator: Installation

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If the A/C evaporator is being replaced, add 60 milliliters (2 fluid ounces) of refrigerant oil to the refrigerant system. Use only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
  1. If removed, install the foam insulator over the A/C evaporator. If the insulator is deformed or damaged, it must be replaced.
  2. Install the A/C evaporator into the lower half of the HVAC housing. Make sure that the evaporator drain within the HVAC housing is clean and unrestricted and that the foam insulator and rubber grommet are properly installed.
  3. Assemble the HVAC housing (Refer to HEATING & AIR CONDITIONING/DISTRIBUTION/HVAC HOUSING - ASSEMBLY) .
  4. Install the HVAC housing (Refer to HEATING & AIR CONDITIONING/DISTRIBUTION/HVAC HOUSING - INSTALLATION) .
scientia non olet · About LEMON Manuals