Test 1A: Accelerometer 1, Accelerometer 2, Internal 1, Output Driver 1, Stored Energy Firing 1
WARNING: This page is about a different car, the 2002 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Prior to performing any air bag system test, go to PRETEST INSPECTION & DIAGNOSTIC PROCEDURE
under DIAGNOSTICS. Perform TEST VER-1: AIR BAG VERIFICATION TEST
after all repairs unless otherwise directed.
Turn ignition switch to ON position. Using DRBIII, if Air Bag Control Module (ACM) is generating active or stored DTCs. If ACM is generating active or stored DTCs, replace ACM. See AIR BAG CONTROL MODULE (ACM) under REMOVAL & INSTALLATION.