LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2002 >> Wrangler SE, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Analog Instrument Panels >> System Tests >> High Beam Indicator Test

High Beam Indicator Test

NOTE: This procedure is for symptom of inoperative high beam indicator. Testing assumes headlights are operating properly. For additional indicator diagnosis, see SYMPTOM IDENTIFICATION  table under SELF-DIAGNOSTIC SYSTEM.
  1. Turn ignition off. Disconnect negative battery cable. Remove instrument cluster. See INSTRUMENT CLUSTER  under REMOVAL & INSTALLATION. Reconnect negative battery cable. Turn ignition on.
  2. Turn headlights on. Select high beams. Using DVOM, check for battery voltage at instrument cluster connector C1 terminal No. 3 (Red/Gray wire). See Figure . If battery voltage is present, replace instrument cluster. If battery voltage is not present, repair open in Red/Gray or Red/Orange wire between instrument cluster and multifunction switch connector terminal No. 17. See Figure . See HEADLIGHTS in SYSTEM WIRING DIAGRAMS article in ELECTRICAL.
scientia non olet · About LEMON Manuals