LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2002 >> Wrangler SE, Standard >> Repair and Diagnosis >> Electrical >> Gauges >> Analog Instrument Panels >> Self-Diagnostic System >> Retrieving & Clearing Diagnostic Trouble Codes

Retrieving & Clearing Diagnostic Trouble Codes

Diagnostic procedures are designed to detect system faults as quickly as possible. Computer system diagnostic fault messages are accessed through Data Link Connector (DLC). See Fig 1 . Chrysler's Diagnostic Readout Box (DRBIII(R)) scan tool or generic scan tool is used to access information from DLC.

  1. Connect scan tool to Data Link Connector (DLC). DLC is a 16-pin connector located on left side of steering column, above brake pedal. Turn ignition on. If scan tool display is not blank, go to next step. If scan tool display is blank, check connections, scan tool cable and power at DLC terminal No. 16 (Pink/White wire). Try scan tool on another vehicle.
  2. Using scan tool, check communication with instrument cluster. If scan tool can communicate with instrument cluster, go to next step. If scan tool displays NO RESPONSE, go to appropriate test under COMMUNICATIONS under SYSTEM TESTS in BODY CONTROL MODULES - WRANGLER article.
  3. Using scan tool, select READ DTCs. If any fault messages are displayed, see DIAGNOSTIC TROUBLE CODE IDENTIFICATION  table. If no DTCs exist, but a symptom is present, repair by symptom. See SYMPTOM IDENTIFICATION  table. After repairs, ensure problem(s) or failure(s) have been corrected by performing appropriate verification test under VERIFICATION TESTS in BODY CONTROL MODULES - WRANGLER article.
Fig 1: Locating 16-Pin Data Link Connector (DLC)
G00010212Courtesy of CHRYSLER CORP.
DIAGNOSTIC TROUBLE CODE IDENTIFICATION

DTC Go To
ACM Message Not Received By MIC (1)
Air Bag Lamp Circuit Open (1)
Air Bag Lamp Circuit Short (1)
Checksum Failure (1)
Panel Dimmer Open (1)
PCM Message Not Received By MIC (1)
SKIM Message Not Received By MIC (1)
(1) Go to appropriate test under INSTRUMENT PANELS under SYSTEM TESTS in BODY CONTROL MODULES - WRANGLER article.
SYMPTOM IDENTIFICATION

Symptom Go To
4WD Indicator inoperative (1)
ABS Indicator Inoperative (1)
Air Bag Indicator Inoperative (1)
All Gauges Inoperative (1)
Any PCI Bus Indicator Inoperative (1)
Brake Warning Indicator Always On (1)
Brake Warning Indicator Inoperative (1)
Fog Lamp Indicator Inoperative (1)
High Beam Indicator Inoperative (1)
No Bus In VF Display (1)
No Fuse In VF Display (1)
One Gauge Inoperative (1)
Panel Dimming Inoperative (1)
Rear Fog Lamp Indicator Inoperative (1)
Seat Belt Indicator Not Operating Properly (1)
VF Display Inoperative (1)
VF Odometer Inoperative With Door Open (1)
(1) Go to appropriate test under INSTRUMENT PANELS under SYSTEM TESTS in BODY CONTROL MODULES - WRANGLER article.