LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (3.0L V6 - VIN [3]) >> Removal & Installation >> Engine >> Removal

Removal & Installation: Engine: Removal

WARNING: This page is about a different car, the 1994 Plymouth Sundance, 1994 Plymouth Acclaim, 1994 Dodge Spirit, 1994 Dodge Shadow, and 1994 Chrysler LeBaron. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release fuel pressure. See FUEL PRESSURE RELEASE  under REMOVAL & INSTALLATION. Disconnect battery cables. Mark hood hinge location on hood. Remove hood. Drain cooling system. Disconnect all electrical connections and vacuum hoses.
  2. Disconnect radiator and heater hoses. Remove radiator and fan assembly. Wrap shop towel around fuel lines. To remove fuel lines from fuel rail, push inward on plastic ring located at end of fuel line fitting and pull fuel line from fitting. Disconnect accelerator cable.
  3. Remove air cleaner assembly. Raise vehicle, and drain engine oil. Remove A/C compressor with hoses attached. Disconnect exhaust pipe at manifolds. Remove transaxle inspection cover.
  4. Mark position of flexplate to torque converter. Remove torque converter mounting bolts. Attach "C" clamp to retain torque converter in transaxle housing. Remove power steering pump with hoses attached, and set aside. Remove lower transaxle-to-block bolts. Remove starter.
    NOTE: Mark mount location on frame for reassembly reference.
  5. Lower vehicle. Disconnect ground strap. Support transaxle. Attach engine hoist to engine. Remove upper transaxle mounting bolts. Mark right engine mount position on right rail support. Remove mount-to-rail bolts.
  6. Remove front engine mount through bolt. Remove left engine mount through bolt from inside wheelwell or insulator bracket-to-transaxle bolts. Remove engine.
scientia non olet · About LEMON Manuals